Started on a Hand Automaton

 

I started putting together this hand Automaton this past week. Here is the process thus far:


Digital sculpt of the hand. It was then split apart before printing. Each finger is made up of six pieces. The front and the back of the fingers are each made up of three pieces, and each front and back will eventually sandwich embroidery floss. The exposed floss acting as a hinge.


The pieces mid print.


The pieces of the hand printed and labeled, so I can remember how the parts connect.


I started the gluing process, however, I paused when my right wrist (one that broke earlier in the year) started to hurt. I going to bring my brace and keep it in my studio just in case this happens again. At least I will be able to work a bit longer then.



Here is the design that I am pulling from for reference (I think I've posted the design for it already). What I am making will be a bit different than the sketch though. The biggest changes is I am removing the toothed belt and the cam will be change because it's the old overly complicated design. 


I'm not sure if I will be able to finish this peice by Open House because I have some bigger assignments coming up for multiple classes, but I'm happy I at least got a start on it.