Not gonna lie, I was not expecting to be going this in depth with planning out these tables, but talking with Shelby on and off this week has brought up a lot of questions I didn't really think about.
This week has primarily been this question:
How do I make a table that be sturdy enough to handle human interaction while also being able to take the table apart for transportation purposes?
The two point of contention were the legs and the top portion of the table that holds the mechanics.
The lefthand sketchbook page is looking into the connection points between the apron, legs and table top and starting to figure how the bottom table top would connect with the top. The apron, leg, top combo that worked the best was image 3. I also talked to a friend of mine who does a mix of woodworking and construction and he recommended this hardware.I will see if I can get find this hardware here or find something like it.
Shelby and I also realized that it would be hard to find a way to make the indents (the lower left hand image on the left sketch) that hold the mechanics on the table. The righthand sketch was Shelby's suggested way of fixing that indent dilemma. There will be a plywood insert that is cut out and glued on the bottom table top along with some moulding. The insert, moulding, and some dowels will help hold the mechanic portion and the acrylic protecting the mechanics in place.
This coming week's primary goal will be gathering supplies to make the tables.
Comments
Post a Comment