I routered and sanded the edges of all of the table tops. I still need to sand some of the surfaces of the table tops, but that should only take around a half hour. Then I can go onto putting the the top portion of the table together (the display area for the mechanics).
Here are reminders of what the table is going to look like put together. along with a more comprehensive visual of the what the hell I'm talking about in the third sketch on this post.
I know this sketch is a bit messy looking but it's basically me working out all the measurements for the bottom table top.
- The table top itself is 14.5" x 16"
- The insert that will be attached to the table top is 10" x 11.5"
- The acrylic sheets that will be inserted into into the base as windows to the mechanics will be 11" x 6" and 9.5" x 6"
- The molding to help hold in the acrylic on the table top will be 10" or 8.5" long
- The legs suspending the top table top and mechanics are 6" x 1.75" x 1.75"
With all of those measurements in mind, I was able to start making some cuts with the help of Shelby (the inserts and the small leg divots that will hold the acrylic panels). She felt more comfortable working with the table saw, but I was still watching to understand how the process works. I may be able to work with saw myself if I have more to cut on it.
Most of my writing time this week went to putting what I have of my support paper rough draft here onto the blog. It is on it's own page. If you go to the home page of the blog, it is one of the tabs towards the top of the page.
I will also be adding some of the comments made from the committee meeting to this post once the meeting over.
Comments
Post a Comment