January 15th - 19th


Construction:

The gears have been a bit of a process. Because the gears (gear mesh) are a different mesh to the cams (pipe mesh), I can't reuse the the cam file to make the gear. Thus, I need to do test fits for the center holes with the dowels. The .25in dowel holes are being finicky. 

Gear Test 2: Center holes too small for dowel, like the shift from .5in to .375in thick, spacing between the spokes is wider because the paint will also take up some space

Gear Test 3: Center hole too big for dowel, made spokes shorter to give the smaller gear some more body while maintain 1in total diameter 

Gear Test 4: Center hole too still to big for dowel but closer, small gear's spokes smaller in the middle to fit in big gear better

Gear Test 5: Center hole still to big but almost there, added a spoke to the small gear for more stability while turning

Gear Test 6: Debating on adding more spokes onto the small gears because I remembered they do need to be compatible with each other as well and not just the big gear

Gear Test 7: Tried a six and seven spoke option for the small gears, I think I like the six spoke best, with the alteration of the extra spoke the dowel hole is a bit too loose again

Gear Test 8: Everything seems to finally be working well





I also sculpted and printed the offset axle parts. Most of them are made for .25in dowels with a length of .75in, 1in, and 1.25in. The Death scene also needs some offset pieces that go from .375in dowels to .25in dowels. Once I knew that all of these pieces would work, I printed out some more during the department meeting. I'll need to print out more next week.



I did another another test cut on the laser cutter. This was more of a test to help the Digital Fab students visualize the laser cutter's features, but it also helped me get a better understanding of the department laser cutter. I was also given access to the our laser cutter's online account, so I can now use it whenever I need to. I may try cutting an official thesis piece next week, since I am more confident with the laser cutter now.

Going to try to keep the print in within these lines.

For the most part managed to get the print within the lines.

For the engraved star, the blue protective cover melted into the final design.


I did a reorganization of my two containers. The left-hand one is a bit more of a catch-all while the right-hand are parts that specifically pertain to the thesis. I may fill the thesis container pretty fast, so I did get a second one of that particular container from the dollar store. 




Here are sketches for the Living Room vignette. There were enough changes from the old layout while accommodating the mechanics that I drew a newer version.

Living Room Old Layout:



Living Room New Layout:



Living Room Mechanics Layout:



Writing:

This week was a continuation on turning my notes into prose. I started jumping around sections a bit more compared to last week along with adding even more notes for myself in future sections and adding some images. I don't think I will be able to turn the whole paper into prose by the 1/31 due date, but I will for sure be able to make those changes for the theory/research forward section of the paper. I think this is primarily because the theory notes/thoughts were more solidified while the connections between the research and construction section plus the inspirations behind the construction aren't as fleshed out. 

For next week, the plan is to finish up turning the research section into prose along with adding more potently clarifying notes for the construction portion of the paper. I will also be visiting the writing center on Thursday to look over my paper and will make some changes based upon their recommendations. 



Comments