January 8th - 12th

 Exhibition: 

I was thinking about the look of the exhibition and how to possibly show my sketches along with the final product. We had discussed the potential of displaying the sketches in our last committee meeting. Maybe printing out all of the sketches on a higher quality paper and posting then along the wall to the right of the window in the Penny? I'm not sure if they would be all nice and neat set up in rows/columns or maybe have them a bit more gumbled but in chronological order.


Construction:

Did a lot more on the construction front this week than I planned, which was great. I did some 3D printing, some laser cutting, and some sketching/planning. 

Started off the week but printing out a bunch of stoppers since they are a universal mechanical component in all of the pieces. Some of the 1in D (diameter) 0.25in (hole diameter) stoppers lifted as they were printing, so one of the sides is slanted instead of the intended flat. For now I've kept them because they are still technically usable, but I may switch them out later.

Here are some images of the pieces printing. The left is 0.5in D 0.25in stoppers. The right is 1in D 0.375in stoppers on the top and 1in D 0.25in stoppers on the bottom. 




I also made some test prints of some gears. I wanted to make sure both the center holes fit tightly over the dowels and figure out what thickness of gear I want. The gears that I have made in the past were 0.25in thick since the prototypes from last year were so small. In my mechanical drawings I've been drawing them as 0.5in thick which may be better for stability purposes in the long run. 

From the particular print (digital file displayed below), I think the 0.25in thickness of the gear is slightly to thin for the project. The 0.375in dowel fit perfectly, but the 0.25in dowel currently does not fit. I will alter my files and do another test print next Monday. I may also try a 0.375in (3/8in) thickness for my next round of tests. 




I did a test with the laser cutter with the hope of eventually cutting the central circle out of acrylic for the crank to go through. I went through the file creation process with Rhino8 to to better help the Digital Fab. students for their future laser cutting project. The next two images are the digital file of the test.




Here is the final result from that test. I found out that if you try to line up your cut based off of the camera's imaging, it is about and 1/8 of an in off from where you would expect it to be. I will most likely try a new test with this new information in mind. Later on this month or early next month.




I started  the planning the mechanics for Walking. It's the most simple mechanics below the table top, but there are so many hinges that rely on that movement.  I am not sure if I want to digitally sculpt/3D print the figures or sculpt them by hand. 




Here are sketches for the Death vignette. I the feeling of wind moving from left to right by having bigger and more movement on the left and it becoming smaller and fewer movements as you move to the right.

Death Vignette Sketches:




Death Vignette Layout:


Death Vignette Mechanical Layout:




Writing: 

This week mostly focused on turning my notes into prose. There were some more small structure shifts as I started writing such as moving paragraphs and splitting some sections. I'm around 5 or 6 of 30 something pages into shifting my notes over into a written format. I will be continuing to shift my notes into writing next week.

I have also set up an appointment for with the writing center to check on the paper on Jan. 25th.

Comments