March 25th - 29th

Construction:

I set up the mechanics for Death. As mentioned in last week's post some of the dowel diameters are smaller than others, thus no longer providing a friction fit. I realized that I also miscounted the amount of offset axle part that I needed, so printed the last parts out on Friday. 




I finally cut the holes into the table top for Walking. I used the router to get cleaner slot cuts and I think this is the only table that needed slots. This table was the most concerning for me because its a lot harder to fix the holes if something goes wrong. 




I was able to grab and some more materials for the project. The dremel bits are to open up the .25in holes of the supports because they currently have a friction fit but need to be loose for those dowels to spin (we don't have anything small enough in the shop). The file are to clean up the small figures. I got a couple of sizes of the heat shrink tubing for the dowels that need a friction fit but currently don't. I wasn't sure what sizes would be best for the job so I got a few option. 




I finally printed out the Living Room figures, and have started physically sculpt them along with the garden figures. 




I started weaving the underground layer for Death.




When I came back around to putting the cranks together this week I noticed I constructed them wrong. The holes on the flat pieces of wood are meant to be on opposing sides versus the same side. When I tried to fix this issue be drilling all the way through, the piece broke. I started to make new pieces this time with both holes drilled all the way through before cutting. 



Writing:

I took a pause on the writing this week in order to see all of the revisions from the committee before making changes or additions. 


Exhibition:

I started to review the exhibition layout space and draw up a couple ways to display the works. This is definitely can and most likely will be changed, but thought it would be good have posted before the committee meeting as a source of discussion.  




I rescanned all of my old sketches for slight better quality along with sketches that have not yet been scanned. Then I started to review what sketches I plan on printing along with what size I am thinking about printing them at. I think I should print in sizes that will fit on the smaller printer in the digital lab in case I need to print out any sketches after Jarret is gone for the summer. Currently on my list of sketches to print, there are 31 (most if not all of the sketches are scattered amongst posts in the blog, but I can also provide sketches if there are any questions). This list excludes Kitchen sketches and more note oriented sketches, but I could potentially add them in. 

Here is the list of sketches thus far: 

8"x10"
  • Death Sketch 1 
  • Death Sketch 2
  • Death Layout 1
  • Living Room Layout 1
  • Living Room Layout 2
  • Living Room Wall Sketch
  • Chair and Coffee Table Sketch
  • Garden Layout 1
  • Garden Layout 2
  • Garden Wall Sketch 
  • Mechanical Parts
  • Mechanical Start Sketch 1
  • Mechanical Start Sketch 2
  • Mechanical Start Sketch 3
  • Table Round v Square
  • Table Insert Option 1
  • Table Insert Option 2
11"x14"
  • Living Room Sketch 1
  • Garden Sketch 1
  • Death Sketch 4
  • Walking Sketch 1
  • Walking Sketch 2
  • Table Start Sketch
  • Table Sketch
16"x20"
  • Death Layout 2
  • Death Mechanical Layout
  • Garden Layout 3
  • Garden Mechanical Layout
  • Living Room Layout 3
  • Living Room Mechanical Layout
  • Walking Mechanical Sketch


I also had a discussion with Jarret last week about the vinyl cutter. He said for more text heavy vinyl, I should go to Agility. Agility does have summer hours, but recommends that I learn to use the cutter, before then end of spring semester while more staff members are around. 




Comments